Warning
If you have any chronical disease or skin disease, or If you are undergoing, or have recently been undergoing a medical skin treatment, you must consult your doctor or dermatologist before using this device.
1. Do not clean your device with hard objects.
2. Do not expose the device to direct sunlight.
3. Do not wash with running water.
4. Do not emerge into water.
5. Do not leave the device in a humid area.
6. Do not use the device for babies and children below the age of 16.
7. If above is voided, the warranty is no longer valid
Overview
1. Treatment head
2. Indicator lights
3. Button for EMS
4. Button for blackhead remover
5. Blackheads extraction tool
6. Charging connector
7. Charging pin
8. USB cable
9. Charging base
10. Charging connector
Charge
Charge through base
Charge device directly
Charging
Charging is finished
EMS function
EMS introduction
Electric Muscle Stimulation uses pain-free micro-currents to expand and contract muscles in a targeted area. This process lifts and sculpts the face with facelift results. The EMS therapy combining with the red light therapy works to activate cells beneath the skin which can create incredible and long-lasting results for many different skin types.
The low faradic current is delivered into the skin, stimulating nerve endings and causing muscles to contract and relax at recurring intervals. This motion is what causes the toning, just as your muscles contract and relax when you do passive exercise.
Improving your facial contours, minimizing fine lines and wrinkles and resulting in smooth and even skin-tone, EMS works towards ultimate radiance from the inside out, restoring your youthful glow.
Results of EMS skin therapy are best when it is used regularly over a long period of time. It is important to note that if you stop using the device, the effect wont remain. It has to be done frequently and long-term to see real results, as the results build over time.
Caution
For hygienic reasons, the device should only be used by one person.
Never leave the device unattended when it is switched ON. Always switch OFF the device after use.
If you experience discomfort or pain, reduce the power.
Using EMS
IMPORTANT NOTE: Do not use the device near metal implants, braces, silicone or botox. Before treatment, remove any jewelry, glasses, contact lenses and hair pins.
1. Clean your face
2. Apply face serum. We highly recommended SkinX+ Gold Face Serum or cream, item no. 110-07.
3. Wait few seconds to let the face serum set in.
4. Press highest button (3) once for low power, twice for medium power and three times for highest power.
NOTE: The function starts working once the treatment head (1) is touching your skin. Move the device smoothly around your face. When using the EMS function, we highly recommend to start at the lowest setting first and build up from there.
Turn off the device by pressing any button for two seconds.
Blackheads extraction tool
Introduction to blackheads extraction tool
When placed over a ¡°congested¡± area of the skin, the suction helps release keratin plug (blackheads). This device comes with 4 changeable heads with different features.
Changeable heads:
1. Microcrystalline head
Microcrystalline head mix gentle abrasion with suction to remove the dead skin and excess sebum, it helps repair and smooth facial skin. This is almost similar to diamond peeling.
2. Small head
Small head with weak suction, suitable for sensitive skin and small area, such as nose tip and nosewing.
3. Narrow head
Narrow head is to reduce wrinkles on the forehead and remove grease on the nosewing. It can also pull and firm the face.
4. Round head
Round head with super suction is to remove blackhead on most areas, such as nose and the lower jaw.
NOTE: Overuse of the blackhead extraction tool can cause bruising. It can cause the capillaries to break so don¡¯t go overboard. Always start from the lowest setting first and build up from there.
Operating suction head function
1. Clean you face thoroughly.
2. For best result cover your face with a warm or damp towel for 2-3 minutes.
3. Press any button to turn on the device.
4. Press the lowest button (4) once for low power, twice for medium power and three times for highest power.
Turn off the device by pressing any button for two seconds.
Specifications
- USB charge interface
- Charging voltage: 5.0 V
- Charging current: 1.0 A
- Battery power: 3.7 V
- Battery capacity: 1200 MaH
- Heating temperature: 40¡À2¡ăC
- Material: ABS+Metal